FREEDOM® Trilaminate 1 Insoles These foot beds are a new step in heat moldable footcare, providing a total contact, multiple density, prefabricated, removable inlay that can be heated and directly molded to the patient’s foot. They offer complete contact with the plantar surface, including the arch, and are suited to help prevent and control problems in the vascularly insensitive and/or hypersensitive foot. These conditions are often a part of major systemic diseases such as diabetes, heart disease, or arthritis.
Full 1/8" top layer of fine-celled ProCellTM EVA molds to the foot with heat and pressure. A 1/16" mid-layer of supportive Poron® — the material of choice for shock absorption and resiliency — helps assure that orthoses won’t “bottom out” with use. Firm base of ProCell EVA provides optimum support without extreme rigidity, insuring shape retention for the entire inlay.
Insole molds best with convection heat at 250-275° F for approximately two to three minutes and will retain its molded shape to contact with the plantar surface of the foot. Use of our Casting Pillow is recommended to achieve the best mold. The health care professional molding the insoles should take care that the foot position during molding is subtalar neutral to avoid building a deformity into the device. Accommodations, such as scaphoid or met pads, can be used above or below the insole during molding to ensure total contact or to relieve high-pressure areas. Generous forefoot shape can be trimmed to fit any shoe.
Sizing based on shoe sizes:
| Size |
Women's |
Men's |
| X-Small |
5 - 7 |
___ |
| Small |
8 - 9 |
6 - 8 |
| Medium |
10 - 11 |
8 - 9 |
| Large |
___ |
10 - 11 |
| X-Large |
___ |
12 - 13 |
HCPCS K0628/A5510 Letter
